Making Our Very Own Fairy Garden Part 2

In my last entry, I discussed how we made our fairy garden. Since then I have been informed that it is a "Princess Garden", not a Fairy Garden. My apologies to our Miniature Master Gardener.

Our Princess Garden was almost complete at the end of the last entry, but we brought in the big guns (my husband) to make some neat wood projects that make the garden even more amazing. He made wooden mushrooms, fence panels, and a ladder for the princesses to get up to their garden.

Mushrooms

Taking inspiration from The Magic Onions, we decided to add mushrooms to our garden.

Here's what you'll need:

• Sphere halves (sold at a craft store, 6 per pack)
• 1/2" Diameter dowel rod
• Nails
• Patio paint- red & white

1. Drill holes in tops. 

To make his life easier, my husband drilled a hole through the center of each sphere half, slightly smaller than the nails he used.

2. Cut dowel rod.

He marked 6 2" long sections on the dowel rod and cut using a saw. The remaining piece of the dowel rod was saved for the top of the ladder.

3. Paint tops.

Our Miniature Master Gardener did this step. She painted the tops red. After they were dry, she added white dots.

4. Nail tops onto the stems. 

And you're done! Amazing little decorations for the amount of effort. They are probably the two-year-old's favorite thing about the Princess Garden as she is constantly rearranging them.

Fence Panels

For each panel, you will need:

• 7 popsicle sticks
• wood glue (preferably outdoor safe)

1. Cut the popsicle sticks in half. 

Cut 3 of the popsicle sticks in half. Set 1 half aside for another panel (or something else).

2. Lay out the pieces. 

Arrange 5 stick halves parallel to each other, about 1/4" apart. Place one of the whole sticks on either side, parallel to the others with the tops (round edges) flush.

3. Glue.

Run a line of glue along the remaining sticks. Place them glue side down onto the other sticks, so that one stick runs 1/2" below all 7 tops and the other stick runs across the bottoms of the half sticks and the middle of the whole sticks. See the picture if I've completely confused you.

Mushroom, Ladder, and Fence

Ladder

Our princesses were using the vine to climb up to their garden, but they decided the vine was starting to look a little worn and they needed a ladder instead.

Materials:

• 16 Popsicle sticks
• 1/2" diameter dowel rod
• Safety wire
• Wood glue

 1. Cut the sticks.

Using a saw, cut 8 of the popsicle sticks in half. Cut the dowel rod into 2 sections approximately 4-6 inches long.

2.  Assemble the panels. 

Arrange 4 of the half sticks parallel to each. Glue a whole stick across the tops of the half sticks. Glue a second whole stick across the bottoms, parallel to the first. Drill a small hole (large enough for the safety wire) in each end of each whole stick.

3. Wire it together.

Lay out the panels end to end. Using safety wire, connect the adjoining holes. Be sure to twist them together tightly and tuck all sharp ends under. At the top of the ladder, use safety wire to attach the dowel rod pieces. Stick the dowel rods into the soil.

And we're done!

Well, we're done for now. Our Master Gardener has mentioned painting the fence and some other projects. I'll be sure to keep you posted if we add anything. For now, they are enjoying the garden. Here are some pictures of the completed project.

Rearranging the Mushrooms

In the Garden

Of course, I had to take a ton of closeups. What photographer could resist such a charming and sweet space! I hope you are inspired to make your own Fairy Princess Garden. Thanks for reading about ours, we have enjoyed making it and playing with it.

Update: The Moss Rose is starting to bloom in the perfect shade of pink!

Making Our Very Own Fairy Garden Part 1

Poking around on the internet one day (which I spend far too much time doing), I stumbled on "The Magic Onions" Blog and instructions on how to make a fairy garden. My little one and I loved the idea and started making plans to make one.

But that was last summer and a lot of plans I had for last summer fell through. We picked up a large planter with purple glaze on clearance, put it in the garage, and left it alone.

When we got back from our vacation this year, we decided to work on the fairy garden idea again. Here's what we did.

Assembling the Planter

For this part, you'll need:

• 1/2 aged barrel (sold at most hardware stores)
• 3-4 wood scraps of similar thickness
• gravel
• sand
• potting soil

Fairy Garden Plan

1. Make a plan. 

First we did some research and looked up the great ideas on The Magic Onions Fairy Gardens. Then I interviewed our own little gardener (who is 5 1/2) about what she thought a fairy garden would need. Here's our plan, written out in step form. I apologize for the quality of the copy, it's been used already and has gotten water on it.

2. Place blocks under the planter.

The blocks will help with drainage and hopefully prevent some rust damage to the porch and planter.

The Half Empty Barrel

Notes on Working with a Whiskey Barrel: Some of the reviews I read said that people were having problems with the slats coming out on these. Some of the slats can be removed easily, but the clerk assured me they wouldn't budge once I had the soil in place. As you are filling your barrel, keep in mind the position of the bands. They may need to be adjusted as you go.

3. Fill 1/3 with gravel. 

When we moved in to our house, the front yard had been "landscaped" by putting in a few shrubs and dumping gravel in between them. One of my first orders of business was to pull out the gravel and replace it with mulch and weed paper. So we have quite the pile of dirty gravel in our backyard, just waiting for the right project. I thought this was it. So we painstakingly washed the gravel and picked out a few favorites. It was hot and dirty work and just when I thought I was making progress, it was time to go in and make some dinner. It would have taken at least 3 full afternoons to wash the gravel. Or I could have made a more efficient gravel cleaning system, but for the amount of gravel we needed, it was much cheaper and easier to pick up a couple bags at the store.

4. Fill 1/3 with sand. 

 We had some sand left over from my sister's wedding (from weighing down the arch). We used 1 1/2 bags of it for this project.

5. Fill 1/3 with potting soil. 

 Fill the barrel to within an inch of the top. (I had some help on this step, as you can see). Now it's all ready for planting!

Painting

We picked up a gazebo and miniature wheelbarrow from the craft store to put in our garden. A few coats of patio paint later, they turned into gorgeous decorations for our garden.

Planting

We used the following plants in our garden:

• 6 Vinca flowers
• 1 Vinca vine
• 1 Dwarf Spruce
• 1 Moss Rose
• 1 Rubra Pussytoes (Ground Cover)

There is a rosemary plant in this picture, but we didn't put it in this garden.The dwarf spruce isn't pictured.

1. Lay out your garden arrangement (with the gazebo in place).

2. Plant the miniature tree.

3. Plant the flowers and other plants.

I had  lots of help for this step. The girls loved digging in the dirt and putting the flowers in place.

Decorating

Fairy Gardens are only limited by your own imagination, so feel free to go wild with the decorations! For ours, we used the following:

• Gazebo
• Wheelbarrow
• Glass Votive Holder (for our tub)
• Miniature Garden Tools- Watering Can, Shears, Trowel
• Tiny Bucket
• Flat Stones
• Pretty Stones

 We tried to keep everything on the same scale as our Playmobil figures. We also added a few other things, but I'll discuss making them in my next post.

1. Lay a river bed. 

We made a hollow in the dirt on one side of the planter. Using the prettiest rocks from our gravel collection,we lined the hollow and pressed them into place.

2. Add a patio/path.

We patted down an area to make a fairly level "flagstone patio" to place our bench on. We then placed more stones to make a path leading to where our ladder would eventually go.

3. Add moss. 

The blog we used for inspiration recommended that we buy a flat of moss, but I scoured 3 different stores and could not find any. Luckily when my husband mowed after our vacation, I found we had our own patch of moss growing beside the house! We dug it up and added it wherever we didn't want any soil exposed. 

Playing

We did a few more projects which I will cover in a separate post. In the mean time, check out some pictures of how the garden looked at the end of this day.

A Word About Henna Tattoos

I've been fascinated by henna tattoos for a while now. I'm not sure when my interest started or where. Last summer, my sisters and I bought our first henna kit and did a few tattoos. This year, a friend asked if I would do henna tattoos for her daughter's birthday party. It sounded like too much fun to pass up (and it was a blast!).

If you are interested in henna tattoos, here are a couple pointers.

1. Invest in a decent kit. 

I've used Earth Henna's Kit (available on Amazon) twice now and loved it both times. It comes with everything you need and the henna lasts 10-15 days, depending on how long you leave the henna on and how much you wash the area. I tried another brand that was much cheaper and I didn't like it at all. The Earth Henna kit has a squeeze bottle applicator with a syringe tip, while the cheaper kit had a bag and nozzle setup that I found nearly impossible to manage.

2. Practice! Practice! Practice!

One of the girls at the party brought a book on the art of henna which recommended you keep a notebook with you to sketch things that might inspire your designs. I practice my henna designs (or Celtic knots) every Sunday. I'm a doodler and can pay attention better if I have something to scribble on. You can check my notes, every blank is filled in, but the top usually looks something like this:

From time to time, I look up new designs on the internet and draw whatever catches my eye. I'd love to give credit to the websites where I got these designs, but I've lost the links. These are hand-drawn (the blue ones with a fountain pen, the black with a fine point pen). I suppose a permanent marker would be a better facsimile for the henna tattoo applicator's width, but I was trying to jot as many ideas as possible on one page.

The kit also suggests you use toothpaste in the applicator to familiarize yourself with it. Our favorite ceramics place uses the same type of applicators so we get lots of practice with them there.

3. Think about design and placement. 

A lot of the above designs are meant for hand placement, but can adapted elsewhere. I've seen some beautiful henna tattoos on pregnant women's bellies. Also, the tattoo will remain for up to two weeks. If your workplace has policies against visible tattoos, you may need to rethink the gorgeous hand design.

Doing a henna tattoo is also a great way to try out the placement of a permanent tattoo. If you apply the design with henna, you'll have a couple weeks to see how easy it is to live with/show off/cover up.

4. Have fun with it!

Traditional style tattoos are gorgeous, but no one said you have to stick to them. At the party, we were drawing unicorns, cats, infinity love symbols, etc. Here are some of the designs we painted:

I hope this helps!

Revitalizing an Old Purse

This next project was one I worked on with my sister late one girls' night. She needed a new purse to fit an iPad. I happened to have on hand an old purse with a pen mark down the front. The purse was only $2 at a thrift store and a nice, soft leather. We pulled out some scraps I had left over from other projects and decided on some dark brown tooled vinyl. Here is what we did.

Leather Purse- Note the pen mark in the middle

Supplies:

• 1 old purse, preferably a good quality leather
• 1 strip tooled vinyl (approx. 6" x 18" ) or large enough to cut the designs you want 
• super glue

Process:

1. Using a sharp pair of scissors, cut the designs you want from the vinyl.

2. Arrange the designs on the purse how you wish.

On our project, we went through several trial designs before my sister decided on one. It isn't the one I would have chosen, but she's content with it and that's the important thing. Here are some of the rejected ideas:

3. Using the super glue, glue the designs in place.

4. And you're done! Simple as that. Total time: 2 hours, Total cost: around $5